Glitz Spritz Example and some instructions Fill to the fill line on the bottle with the liquid of your choice (water, hair spray, acrylic varnish etc) and shake well before EACH use even if it has only been a minute or two since you used it as the dry ingredients tend to settle. The easiest way to use the Mist is just to spray your surface. Either air dry or heat dry with your heat gun. Add several colours for a wonderful metallic polka dot effect. However, a quick 'shot' of hair spray sometimes intensifies the colours. Experiment and see what effect you like. Try placing a stencil onto your surface leaving a border of paper around the stencil. Spritz lightly or heavily as desired. Gently lift off the stencil for an easy and elegant effect. For your journals and altered books, spray lightly around the outside of the page leaving the centre relatively clear. This ages the page and puts instant colour on it. Card example Card instructions Using Glitz Spritz in Polished Copper spray a black card stock heavily until it looks like a large puddle. Quickly take a wadded-up piece of paper toweling and dab over entire paper until it looks like marble. Dry. Seal with hair spray. Foreground: Using a black COATED tag (uncoated tags will not give the same effect), spritz entire tag with Polished Copper Glitz Spritz until it beads up on tag. Dry with embossing gun. Seal with hair spray. Dry again (because of the coating, the Glitz Spritz does not air dry well). Using Moon Glow Embossing Powder in Midnight Emerald Obsidian stamp an all-over design. Brush off excess powder. to colour chart back to inking